MORE REALISTIC DISTANCES + A FEW OTHER FIXES Mod

ATS Other


MORE REALISTIC DISTANCES + A FEW OTHER FIXES Mod

At first when I started experimenting with the map scale, I wanted to make it more ETS2-like but when I did that, some things changed badly, so I started experimenting further. After more than 10 attempts I finally managed to make distances more realistic and yet keep the scaling close to the default, so that most of the things remain the same. The thing is, when I started editing the map, I forgot Mantrid’s map was already in the mod folder, so here’s what’s different about this map:

1. Mantrid’s changes regarding the too low speed limits on the highway and a traffic light near Tonopah.
2. Realistic distances (i.e San Diego – Redding ~ 650 mph, instead of the default value which makes that distance a little more than 800 mph; I used several web sites for calculating distances by car).
3. Time runs just a bit slower. Not too slow but not too fast either.
4. Reducing the map scale also partially fixed the problem with the insufficient fuel tank even when it’s 100% full and with eco skill. I say “partially” because now I arrive at the destination not with half tank but with about 70% (rougly calculated) full tank.

I would like to make timer to run slower and yet keep the current distances but for that SCS will have to recalculate map scale to match the difference between KPH and MPH. At the moment it doesn’t seem to be matching that difference.

The default map scale is 34.50000. I reduced it down to 31.92808.


Credits
Lexx

How to install ETS2 mods or ATS Mods

In Euro Truck Simulator 2 it’s easy to install mods. You just need to download mod from here, copy/unzip files into: “My Documents\Euro Truck Simulator 2\mod” folder or if you play ATS please install mods to: “My Documents\American Truck Simulator\mod” folder. To unzip files you can use: WinRAR or 7zip. After that you need to activate the mods you want to use.






You may also like...

Leave a Reply

Your email address will not be published. Required fields are marked *